Pesquisa

Edição
Título
Autores
Volume 2019, Nº 7 (2019)
Technological Schemes and Conditions for the Production of Rolling Rings from Hollow As-Cast Blanks
Kostyshev V., Erisov Y.
PDF
(Eng)
Volume 2019, Nº 2 (2019)
Calorimetric Study of the Formation of Liquid Ag–Cu–Sn Alloys. Enthalpy of Mixing for the Boundary Binary Cu–Ag, Cu–Sn, and Ag–Sn Systems at 1150°C
Oleinik K., Bykov A.
PDF
(Eng)
Volume 2018, Nº 4 (2018)
Structure Formation and Hardening of the Hybrid Material Based on Vanadium and Zirconium Alloys during High-Pressure Torsion
Rogachev S., Nikulin S., Khatkevich V., Tabachkova N., Sundeev R.
PDF
(Eng)
Volume 2019, Nº 8 (2019)
Thermal Analysis of the Fabrication of Magnesium Master Alloys Containing Yttrium and Zinc
Savchenkov S., Bazhin V., Brichkin V., Ugolkov V.
PDF
(Eng)
Volume 2019, Nº 13 (2019)
Mass Transfer of a Nanocrystalline 5BDSR Alloy during Low-Voltage Electrospark Treatment
Kuznetsov I., Kolomeichenko A.
PDF
(Eng)
Volume 2019, Nº 10 (2019)
Amorphous-Alloy-Based Composites Prepared by High-Pressure Torsion
Permyakova I., Blinova E., Shchetinin I., Savchenko E.
PDF
(Eng)
Volume 2019, Nº 2 (2019)
Structure of the Al90Y10 Alloy Formed upon Pressure Solidification
Menshikova S., Shirinkina I., Brodova I., Brazhkin V.
PDF
(Eng)
Volume 2018, Nº 11 (2018)
Effect of the Cobalt Content and Chromium Alloying on the Structure of the Scale Formed on Structural β-NiAl + γ'-Ni3Al + γ-Ni Alloys (Ni–Al–Co System) at 1300°C
Drozdov A., Povarova K., Bazyleva O., Morozov A., Antonova A., Arginbaeva E., Bulakhtina M., Ashmarin A.
PDF
(Eng)
Volume 2018, Nº 6 (2018)
Properties of the Coatings Fabricated by Plasma-Jet Hard-Facing by Dispersed Mechanical Engineering Wastes
Latypov R., Ageev E., Latypova G., Altukhov A., Ageeva E.
PDF
(Eng)
Volume 2018, Nº 1 (2018)
Structure and Tribological Properties of B83 Babbit–Based Composite Rods and the Coatings Produced from Them by Arc Surfacing
Bolotova L., Kalashnikov I., Kobeleva L., Katin I., Kolmakov A., Mikheev R., Kobernik N., Podymova N.
PDF
(Eng)
Volume 2017, Nº 12 (2017)
Experience of Application of EBW in Producing Welded VT41 Alloy Drums in the Design of an HPC in an Advanced Engine
Bykov Y., Fomichev E., Kashapov O., Kyaramyan K.
PDF
(Eng)
Volume 2017, Nº 9 (2017)
Structural heat-resistant β-NiAl + γ′-Ni3Al alloys of the Ni–Al–Co system: II. Oxidation
Povarova K., Drozdov A., Bazyleva O., Morozov A., Antonova A., Arginbaeva E., Alad’ev N., Sirotinkin V.
PDF
(Eng)
Volume 2017, Nº 4 (2017)
Effect of deformation and heat treatment on the structure, the mechanical properties, and the fracture characteristics of an ultrafine-grained Zr–1Nb alloy
Vinokurov V., Grabovetskaya G., Stepanova E., Mishin I.
PDF
(Eng)
Volume 2016, Nº 10 (2016)
Fatigue strength of a Ti–6Al–4V alloy produced by selective laser melting
Gerov M., Vladislavskaya E., Terent’ev V., Prosvirnin D., Kolmakov A., Antonova O.
PDF
(Eng)
Volume 2019, Nº 13 (2019)
Elemental Composition and Microhardness of the Coatings Prepared on Faced Aluminum Alloys by Plasma Electrolytic Oxidation in a Silicate–Alkaline Electrolyte
Kolomeichenko A., Kravchenko I.
PDF
(Eng)
Volume 2019, Nº 10 (2019)
Effect of Thermohydrogen Treatment on the Manufacturing and Mechanical Properties of a Heat-Resistant VTI-4 Intermetallic Alloy
Skvortsova S., Pozhoga O., Ovchinnikov A., Orlov A.
PDF
(Eng)
Volume 2019, Nº 6 (2019)
Conditions of Air Shot Hardening of VT41 Titanium Alloy Blisk Blades for an Advanced Engine
Yakovlev M., Kyaramyan K., Shirvan’yants G.
PDF
(Eng)
Volume 2018, Nº 11 (2018)
Structure and Properties of the Solid-Phase Joints of a Wrought EP975 Nickel Alloy and a Single-Crystal Intermetallic VKNA-25 Alloy Formed by Pressure Welding at a Strain of 24% under the Superplasticity of the EP975 Alloy
Galieva E., Povarova K., Drozdov A., Valitov V.
PDF
(Eng)
Volume 2018, Nº 6 (2018)
Effect of the Heat-Treatment Conditions on the Structure and Mechanical Properties of the Base and Weld Materials of the VT41 Alloy Blisks in the HPC of an Advanced Engine
Nochovnaya N., Kashapov O., Bykov Y., Kyaramyan K.
PDF
(Eng)
Volume 2018, Nº 4 (2018)
Phase Composition, Texture, and Residual Stresses in Al–Cu–Li Friction Stir Welds
Betsofen S., Lukin V., Dolgova M., Panteleev M., Kabanova Y.
PDF
(Eng)
Volume 2018, Nº 1 (2018)
Formation of Gradient Structures in the Zone of Joining a Deformable Nickel Alloy and a Single-Crystal Intermetallic Alloy during Thermodiffusion Pressure Welding and Subsequent Heat Treatment
Povarova K., Valitov V., Drozdov A., Bazyleva O., Galieva E., Arginbaeva E.
PDF
(Eng)
Volume 2017, Nº 11 (2017)
Electrochemical Behavior of an Amorphous and Nanocrystalline Fe79P13Si5V3 Alloy in a Damp SO2-Contaminated Atmosphere
Vavilova V., Korneev V., Gavrilov D., Anosova M.
PDF
(Eng)
Volume 2017, Nº 7 (2017)
Solidification of the eutectic Sn–43 mol % Bi alloy
Aleksandrov V., Frolova S., Zozulya A.
PDF
(Eng)
Volume 2017, Nº 3 (2017)
Solid-state oxidation kinetics of an yttrium-containing AK1M2 alloy
Berdiev A., Ganiev I., Niezov K.
PDF
(Eng)
Volume 2016, Nº 8 (2016)
Choice of quenching temperature and its effect on the structure and properties of a high-strength grade 01979 aluminum alloy
Kuptsov S., Elantsev A., Nikonenko E., Nikitina E.
PDF
(Eng)
1 - 25 de 94 resultados 1 2 3 4 > >> 
Dicas:
  • Palavras-chave são sensíveis a maiúsculas
  • Preposições e conjunções ingleses são ignoradas
  • Busca é feita por todos os palavras-chave (agente AND experimentador) por omissão
  • Use OR para pesquisar um termo exato, ex.: educação OR formação
  • Use parênteses para criar frases complexas, ex.: arquivo de ((revistas OR conferências) NOT teses)
  • Para pesquisar uma frase precisa use aspas duplas, ex.: "investigações científicas"
  • Exclua uma palavra utilizando o sinal - (hífen) ou operador NOT; ex.: concurso-de beleza ou concurso NOT de beleza
  • Use * como caractere-coringa, ex.: científic* recuperará as palavras "científico", "científicos", etc.

Este site utiliza cookies

Ao continuar usando nosso site, você concorda com o procedimento de cookies que mantêm o site funcionando normalmente.

Informação sobre cookies