Pesquisa

Edição
Título
Autores
Comparative Analysis of Stressed State in Torispherical and Elliptical Heads of Pressure Vessels
Skopinskii V., Stolyarova N., Berkov N.
Development of a Mixer Design Using Numerical Methods to Calculate Flow Hydrodynamics in the Working Volume
Tarantsev K., Ponikarov S., Tarantseva K.
State of Gas in a Piston Compressor at the Start of Compression
Shatalov I., Antinov Y., Smirnov S., Mamaev V., Ramazanov É., Shkarin K.
Calculation of Flanged Joint with Optimal Gasket Width
Prodan V., Bozhko G., Vasil’ev A., Cheremukhin V.
A Mathematical Description of the Metrological Characteristics of a Reflector Manometer
Buzanovskii V.
Improving the Efficiency of a Gifford–Mcmahon Cryogenic Refrigerator
Kravchenko M., Lavrenchenko G.
Compensation for Nitrogen Loss in the Atmosphere of a Hermetically Sealed Inhabited Object
Levchenko A., Artem’ev O., Lavrov N., Kazakova A., Nikiforov Y., Bilalov M.
Influence of Angle of Slope of Blades on Operation of Centrifugal Turbine
Pavlechko V.
Tubeless Face Gland Seal
Prodan V., Bozhko G., Fokina M.
Analysis of the Performance of Industrial Adsorbers
Yusubov F., Bairamova A.
Modeling of Gaseodynamic Processes at a Pressure Reduction Point with the Use of a Volumetric Expander−Generator Set to Assure Safe Recycling of the Energy of Compressed Natural Gas
Belousov A., Samigullin G., Kleimenov A.
Gland Seal with Soft Packing of Trapezoidal Cross Section and Inside Seating of the Pressure Flange
Prodan V., Bozhko G., Bogdanov O., Boiko P., Fokina M.
Calculation of the Radial Force in the Groove Seal of a Rotor with Stationary or Rotating Shaft
Mel’nik V.
Effective Use of DP-PSA Gas Separation Technology
Kravchenko M., Lavrenchenko G.
Calculation of Pressure Drop in Unirrigated Packed Contact Devices Applying ANSYS Fluent Software
Faizov A., Churakova S., Sidorov G.
Combined System for Degassing Working Fluid and Pump Charging
Abramov V., Mikhailov A., Shram V., Sokol’nikov A., Afanasov V.
Reinforcing the Holes in High-Pressure Vessels
Pimshtein P., Barabanova L.
Assessment of Energy Efficiency of Sections of a Gas-Transporting System with Replaced Flow Passages of Centrifugal Compressors Having Reduced Rated Pressure Ratio
Vanyashov A., Vasenko E.
Bench Testing of a Pump with a Self-Adjusting Impeller
Gorovoi S.
Strength Calculations and Calculation of the Remaining Life of Autofrettaged Components of Tubular Equipment and Pipelines
Kabanova O., Golodnenko D.
Numerical Analysis of Gas Dynamic Efficiency of Short Diffusers with Internal Guiding Blades
Yusha V., Fil’kin N.
Optimum Temperature of Intermediate Heat Carrier in Oil Emulsion Heaters
Pechenegov Y.
Selection of Structural Dimensions of Twin Liners of a Mud Pump Cylinder and Calculation of Strength of Coupling with Assured Tightness
Iskenderli I., Narimanov V.
Modeling of the Initial Parameters in the Adjustment of an Oil Recovery Process Control System. Part 2. Determination of Limits on the Vectors of the State Variables and Disturbances*
Batalov S.
An Approximate Method of Determining the Load of Plastic Failure in Pressure Vessels with Nozzles
Skopinskii V., Berkov N.
1 - 25 de 27 resultados 1 2 > >> 
Dicas:
  • Palavras-chave são sensíveis a maiúsculas
  • Preposições e conjunções ingleses são ignoradas
  • Busca é feita por todos os palavras-chave (agente AND experimentador) por omissão
  • Use OR para pesquisar um termo exato, ex.: educação OR formação
  • Use parênteses para criar frases complexas, ex.: arquivo de ((revistas OR conferências) NOT teses)
  • Para pesquisar uma frase precisa use aspas duplas, ex.: "investigações científicas"
  • Exclua uma palavra utilizando o sinal - (hífen) ou operador NOT; ex.: concurso-de beleza ou concurso NOT de beleza
  • Use * como caractere-coringa, ex.: científic* recuperará as palavras "científico", "científicos", etc.

Este site utiliza cookies

Ao continuar usando nosso site, você concorda com o procedimento de cookies que mantêm o site funcionando normalmente.

Informação sobre cookies