Analysis of Frictional Resistance Arising at the Edge of the Sheet Metal Drawing Die
- Autores: Bosiakov S.1, Trzepiecinski T.2
-
Afiliações:
- Belarusian State University
- Rzeszow University of Technology
- Edição: Volume 40, Nº 2 (2019)
- Páginas: 151-155
- Seção: Article
- URL: https://journals.rcsi.science/1068-3666/article/view/229277
- DOI: https://doi.org/10.3103/S106836661902003X
- ID: 229277
Citar
Resumo
The paper presents the results of the experimental studies of the frictional resistance of sheet metal used in the automotive industry in the process of its formation. The friction tests are carried out on a special installation designed to reproduce the friction resistance arising at the edge of the die during the metal sheet drawing. It is established that the friction factor can vary significantly in the process of sheet deformation. A comparative analysis of the experiment results and the finite-element sheet drawing simulation is carried out. It is shown that the developed finite-element model allows adequately determining the friction factor under large metal deformations.
Palavras-chave
Sobre autores
S. Bosiakov
Belarusian State University
Autor responsável pela correspondência
Email: bosiakov@bsu.by
Belarus, Minsk, 220030
T. Trzepiecinski
Rzeszow University of Technology
Email: bosiakov@bsu.by
Polônia, Rzeszow, 35-959
Arquivos suplementares
