Analysis of Frictional Resistance Arising at the Edge of the Sheet Metal Drawing Die


Дәйексөз келтіру

Толық мәтін

Ашық рұқсат Ашық рұқсат
Рұқсат жабық Рұқсат берілді
Рұқсат жабық Тек жазылушылар үшін

Аннотация

The paper presents the results of the experimental studies of the frictional resistance of sheet metal used in the automotive industry in the process of its formation. The friction tests are carried out on a special installation designed to reproduce the friction resistance arising at the edge of the die during the metal sheet drawing. It is established that the friction factor can vary significantly in the process of sheet deformation. A comparative analysis of the experiment results and the finite-element sheet drawing simulation is carried out. It is shown that the developed finite-element model allows adequately determining the friction factor under large metal deformations.

Авторлар туралы

S. Bosiakov

Belarusian State University

Хат алмасуға жауапты Автор.
Email: bosiakov@bsu.by
Белоруссия, Minsk, 220030

T. Trzepiecinski

Rzeszow University of Technology

Email: bosiakov@bsu.by
Польша, Rzeszow, 35-959

Қосымша файлдар

Қосымша файлдар
Әрекет
1. JATS XML

© Allerton Press, Inc., 2019