High-Speed Contact Study between a Ti-6-Al-4V Tool and an Abradable Coating Using Ballistic Benches and a Dynamic Compensation Approach


Citar

Texto integral

Acesso aberto Acesso aberto
Acesso é fechado Acesso está concedido
Acesso é fechado Somente assinantes

Resumo

To reproduce severe and short-lived contacts like those occurring between the blade tip of an aircraft engine and the abradable material coated inside the engine casing, ballistic benches can be used. These devices allow to achieve a large range of velocities and thus, they allow the study of the abrasion process and the resulting wear of these kind of sealing materials. The Al-based abradable characterized within this work have been grown by atmospheric plasma spraying on a titanium substrate that was afterwards mounted on top of an aluminum projectile. Due to the short-lived forces occurring during these kind of contacts, the dynamic behavior of the device itself strongly affects the measured force signals. In order to overcome these dynamic distortions, we present a compensation approach able to perform a virtual extension of the available dynamometer bandwidth. This approach is based on an inverse-filtering of the response signal by using a 3 × 3 force-to-force transmissibility matrix function. The validated compensation approach was used to characterize the relation between the full three-dimensional measured contact-force and the specimen wear occurring during the abradable/Ti-6-Al-4V high-speed interaction.

Sobre autores

Andrea Cappella

LEM3, Laboratoire d’Etude des Microstructures et de Mécanique des Matériaux

Autor responsável pela correspondência
Email: andrea.cappella@univ-lorraine.fr
França, Metz, 57045

Julien Vincent

LEM3, Laboratoire d’Etude des Microstructures et de Mécanique des Matériaux

Email: andrea.cappella@univ-lorraine.fr
França, Metz, 57045

Sylvain Philippon

LEM3, Laboratoire d’Etude des Microstructures et de Mécanique des Matériaux

Email: andrea.cappella@univ-lorraine.fr
França, Metz, 57045

Laurent Faure

LEM3, Laboratoire d’Etude des Microstructures et de Mécanique des Matériaux

Email: andrea.cappella@univ-lorraine.fr
França, Metz, 57045

Arquivos suplementares

Arquivos suplementares
Ação
1. JATS XML

Declaração de direitos autorais © Allerton Press, Inc., 2017