Investigation of the Thermomechanical Characteristics of Feedstocks with Different Binder Types
- Authors: Muranov A.N.1, Semenov A.B.1, Marakhovskii P.S.2, Chutskova E.Y.2, Semenov B.I.1
-
Affiliations:
- Bauman Moscow State Technical University (National Research University)
- All-Russian Scientific Research Institute of Aviation Materials (VIAM), State Scientific Center of the Russian Federation
- Issue: Vol 10, No 4 (2019)
- Pages: 959-965
- Section: Article
- URL: https://journals.rcsi.science/2075-1133/article/view/208033
- DOI: https://doi.org/10.1134/S2075113319040269
- ID: 208033
Cite item
Abstract
A description is given of mass production technology for metal small-sized precision parts with a complicated configuration—the injection molding of polymer–powder mixtures under high pressure. For polymer–powder mixtures with the most common types of polymeric binders, the effect of the binder composition exerted on the thermomechanical characteristics is studied, on the basis of which a comparative assessment of the manufacturability of the mixtures under molding is presented.
About the authors
A. N. Muranov
Bauman Moscow State Technical University (National Research University)
Author for correspondence.
Email: MuranovAlecs@mail.ru
Russian Federation, Moscow, 105005
A. B. Semenov
Bauman Moscow State Technical University (National Research University)
Email: MuranovAlecs@mail.ru
Russian Federation, Moscow, 105005
P. S. Marakhovskii
All-Russian Scientific Research Institute of Aviation Materials (VIAM), State Scientific Center of the Russian Federation
Email: MuranovAlecs@mail.ru
Russian Federation, Moscow, 105005
E. Yu. Chutskova
All-Russian Scientific Research Institute of Aviation Materials (VIAM), State Scientific Center of the Russian Federation
Email: MuranovAlecs@mail.ru
Russian Federation, Moscow, 105005
B. I. Semenov
Bauman Moscow State Technical University (National Research University)
Email: MuranovAlecs@mail.ru
Russian Federation, Moscow, 105005