Email this article Study of Formation of Welded Joint Produced by Laser Overlap Welding of Aluminum AMg2M Alloy and St3 Steel
- Authors: Lyukhter A.B.1, Shlegel A.N.2, Gusev D.S.1,3, Samarin S.S.1
-
Affiliations:
- Engineering Center for the Use of Laser Technologies in Mechanical Engineering
- New Technologies of Laser Thermal Hardening LLC
- EC at VSU LLC
- Issue: Vol 9, No 4 (2018)
- Pages: 709-713
- Section: Article
- URL: https://journals.rcsi.science/2075-1133/article/view/207596
- DOI: https://doi.org/10.1134/S2075113318040214
- ID: 207596
Cite item
Open Access
Access granted
Subscription Access
Abstract
In this experimental study, we used an aluminum AMg2M alloy and St3 steel as proxies to determine the discontinuity, the ultimate strength, the value of the relative elongation, and the width and depth of the welded joint as a function of the technological parameters of laser overlap welding. The physical and mechanical properties of the welded joints were found to be close to those of AMg2M.
About the authors
A. B. Lyukhter
Engineering Center for the Use of Laser Technologies in Mechanical Engineering
Author for correspondence.
Email: 3699137@mail.ru
Russian Federation, Vladimir, 600014
A. N. Shlegel
New Technologies of Laser Thermal Hardening LLC
Email: 3699137@mail.ru
Russian Federation, Vladimir, 600023
D. S. Gusev
Engineering Center for the Use of Laser Technologies in Mechanical Engineering; EC at VSU LLC
Email: 3699137@mail.ru
Russian Federation, Vladimir, 600014; Vladimir, 600000
S. S. Samarin
Engineering Center for the Use of Laser Technologies in Mechanical Engineering
Email: 3699137@mail.ru
Russian Federation, Vladimir, 600014
