Email this article Comparative Analysis of Technological Properties and Microstructure of Titanium Powders of Different Classes
- Authors: Leonov V.P.1, Malinkina Y.Y.1, Drugachuk S.D.1, Khachaturyan I.M.1, Chudakov E.V.1
-
Affiliations:
- Crystal Institute
- Issue: No 1(117) (2024)
- Pages: 86-98
- Section: Functional materials
- URL: https://journals.rcsi.science/1994-6716/article/view/306056
- DOI: https://doi.org/10.22349/1994-6716-2024-117-1-86-98
- ID: 306056
Cite item
Open Access
Access granted
Subscription Access
Abstract
The results of a study of the technological properties of titanium powders of pseudo-α and pseudo-β alloys are presented. A comparative analysis of the characteristics of powder materials obtained by centrifugal spraying has been carried out. The results of the granulometric composition of the powders were obtained, and the calculation of the spatial packing of particles was applied within the framework of the hard sphere model for various fractional compositions. To compare the microstructure and mechanical properties, test samples from pseudo-α and pseudo-β titanium alloys were obtained using the hot isostatic pressing method according to selected modes.
About the authors
V. P. Leonov
Crystal Institute
Author for correspondence.
Email: VLeonov@crism.ru
Dr. Sc. (Eng) Petrovskaya St., 49, St. Petersburg, Russia
Yu. Yu. Malinkina
Crystal Institute
Email: VLeonov@crism.ru
Cand. Sc. (Eng) Petrovskaya St., 49, St. Petersburg, Russia
S. D. Drugachuk
Crystal Institute
Email: VLeonov@crism.ru
Cand. Sc. (Eng) Petrovskaya St., 49, St. Petersburg, Russia
I. M. Khachaturyan
Crystal Institute
Email: VLeonov@crism.ru
Petrovskaya St., 49, St. Petersburg, Russia
E. V. Chudakov
Crystal Institute
Email: VLeonov@crism.ru
Cand. Sc. (Eng) Petrovskaya St., 49, St. Petersburg, Russia
References
Supplementary files
