Email this article Influence of Various Factors on the Wear Process of Electrolytic Nickel-Phosphorus Coatings
- Authors: Aslanyan I.R.1, Emaev I.I.2, Shuster L.S.2
-
Affiliations:
- Engineering Center JSC “United Engine Corporation,”
- Ufa State Aviation Technical University
- Issue: Vol 55, No 7-8 (2019)
- Pages: 663-668
- Section: Materials Science. Corrosion Protection
- URL: https://journals.rcsi.science/0009-2355/article/view/236661
- DOI: https://doi.org/10.1007/s10556-019-00676-9
- ID: 236661
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of SiC additives and annealing on the wear of electrolytic nickel-phosphorus coatings under different friction conditions (sliding, fretting wear, and fretting corrosion) was studied. It was found that wear of coatings due to sliding friction is much lower than due to fretting wear and fretting corrosion. It is shown that in most of the considered friction conditions the least wear is provided by the heattreated nickel-phosphorus coating without SiC additives.
About the authors
I. R. Aslanyan
Engineering Center JSC “United Engine Corporation,”
Author for correspondence.
Email: as-irina@rambler.ru
Russian Federation, Moscow
I. I. Emaev
Ufa State Aviation Technical University
Email: as-irina@rambler.ru
Russian Federation, Ufa
L. Sh. Shuster
Ufa State Aviation Technical University
Email: as-irina@rambler.ru
Russian Federation, Ufa
