Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery
- Авторы: Mishinov S.V.1, Stupak V.V.1, Mamonova N.V.2, Panchenko A.A.3, Krasovsky I.B.3, Lazurenko D.V.4
-
Учреждения:
- Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
- OOO Engineering Medical-Technology Center
- OOO Logeeks
- Novosibirsk State Technical University
- Выпуск: Том 51, № 2 (2017)
- Страницы: 106-110
- Раздел: Article
- URL: https://journals.rcsi.science/0006-3398/article/view/234947
- DOI: https://doi.org/10.1007/s10527-017-9694-7
- ID: 234947
Цитировать
Аннотация
The methods of three-dimensional printing widely used in the Russian Federation are discussed: FDM, SLA, SLS, and DMLS. Our own experience with three-dimensional modeling and prototyping of implants for reconstructive neurosurgical procedures is analyzed. An optimal method for three-dimensional printing of implants by direct laser metal sintering is developed and supported by evidence.
Об авторах
S. Mishinov
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
Автор, ответственный за переписку.
Email: smishinov@yandex.ru
Россия, Novosibirsk
V. Stupak
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
Email: smishinov@yandex.ru
Россия, Novosibirsk
N. Mamonova
OOO Engineering Medical-Technology Center
Email: smishinov@yandex.ru
Россия, Novosibirsk
A. Panchenko
OOO Logeeks
Email: smishinov@yandex.ru
Россия, Novosibirsk
I. Krasovsky
OOO Logeeks
Email: smishinov@yandex.ru
Россия, Novosibirsk
D. Lazurenko
Novosibirsk State Technical University
Email: smishinov@yandex.ru
Россия, Novosibirsk
Дополнительные файлы
