Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery
- 作者: Mishinov S.V.1, Stupak V.V.1, Mamonova N.V.2, Panchenko A.A.3, Krasovsky I.B.3, Lazurenko D.V.4
-
隶属关系:
- Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
- OOO Engineering Medical-Technology Center
- OOO Logeeks
- Novosibirsk State Technical University
- 期: 卷 51, 编号 2 (2017)
- 页面: 106-110
- 栏目: Article
- URL: https://journals.rcsi.science/0006-3398/article/view/234947
- DOI: https://doi.org/10.1007/s10527-017-9694-7
- ID: 234947
如何引用文章
详细
The methods of three-dimensional printing widely used in the Russian Federation are discussed: FDM, SLA, SLS, and DMLS. Our own experience with three-dimensional modeling and prototyping of implants for reconstructive neurosurgical procedures is analyzed. An optimal method for three-dimensional printing of implants by direct laser metal sintering is developed and supported by evidence.
作者简介
S. Mishinov
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
编辑信件的主要联系方式.
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
V. Stupak
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
N. Mamonova
OOO Engineering Medical-Technology Center
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
A. Panchenko
OOO Logeeks
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
I. Krasovsky
OOO Logeeks
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
D. Lazurenko
Novosibirsk State Technical University
Email: smishinov@yandex.ru
俄罗斯联邦, Novosibirsk
补充文件
