Enviar artigo por via de e-mail Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery
- Autores: Mishinov S.V.1, Stupak V.V.1, Mamonova N.V.2, Panchenko A.A.3, Krasovsky I.B.3, Lazurenko D.V.4
-
Afiliações:
- Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
- OOO Engineering Medical-Technology Center
- OOO Logeeks
- Novosibirsk State Technical University
- Edição: Volume 51, Nº 2 (2017)
- Páginas: 106-110
- Seção: Article
- URL: https://journals.rcsi.science/0006-3398/article/view/234947
- DOI: https://doi.org/10.1007/s10527-017-9694-7
- ID: 234947
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
The methods of three-dimensional printing widely used in the Russian Federation are discussed: FDM, SLA, SLS, and DMLS. Our own experience with three-dimensional modeling and prototyping of implants for reconstructive neurosurgical procedures is analyzed. An optimal method for three-dimensional printing of implants by direct laser metal sintering is developed and supported by evidence.
Sobre autores
S. Mishinov
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
Autor responsável pela correspondência
Email: smishinov@yandex.ru
Rússia, Novosibirsk
V. Stupak
Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
Email: smishinov@yandex.ru
Rússia, Novosibirsk
N. Mamonova
OOO Engineering Medical-Technology Center
Email: smishinov@yandex.ru
Rússia, Novosibirsk
A. Panchenko
OOO Logeeks
Email: smishinov@yandex.ru
Rússia, Novosibirsk
I. Krasovsky
OOO Logeeks
Email: smishinov@yandex.ru
Rússia, Novosibirsk
D. Lazurenko
Novosibirsk State Technical University
Email: smishinov@yandex.ru
Rússia, Novosibirsk
Arquivos suplementares
