Influence of tolerances of main dimensions of flow part of a centrifugal pump on spread of its basic parameters
- Authors: Sheipak A.A.1, Chivileva M.S.1, Sheipak I.A.2
-
Affiliations:
- Moscow State Industrial University
- Lomonosov Moscow State University
- Issue: Vol 7, No 2-1 (2013)
- Pages: 252-257
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/68361
- DOI: https://doi.org/10.17816/2074-0530-68361
- ID: 68361
Cite item
Full Text
Abstract
The article presents the method of calculating the influence of the tolerances of main dimensions of flow part of a centrifugal pump on the spread of pressure values efficiency and critical cavitation margin with the nominal feed rate. There are discussed both symmetric and unilateral deviations of sizes.
Full Text
##article.viewOnOriginalSite##About the authors
A. A. Sheipak
Moscow State Industrial University
Email: asheyp@msiu.ru
Dr. Eng., Prof.; +7 (495) 939-55-40; +7 (495) 726-10-39
M. S. Chivileva
Moscow State Industrial University+7 (495) 939-55-40; +7 (495) 726-10-39
I. A. Sheipak
Lomonosov Moscow State University
Email: asheyp@msiu.ru
Dr. Sc.; +7 (495) 939-55-40; +7 (495) 726-10-39
References
- Шейпак А.А. Влияние технологических отклонений размеров проточной части динамического пневмопривода на изменение его КПД. Машиностроение и инженерное образование. 2009, №4 (21), с. 2-10 (0)
- Лепешкин А.В., Михайлин А.А., Шейпак А.А. Гидравлика и гидропневмопривод. Часть 2-ая, Гидравлические машины и гидропневмопривод: Учебник / Под ред. А.А. Шейпака. - 5-е изд., доп. и перераб. - М: МГИУ, 2008. -352 с.
- Берков Н.А., Миносцев В.Б., Шишанин О.Е. Курс высшей математики ч.3 -МГИУ, 2007. - 192 c.