Simulation of Tool Contact with a Workpiece When Processing by Smoothing in the Kompas 3D Software
- Authors: Kuznetsov VA1, Sazonov DA1, Smirnov AV1
-
Affiliations:
- MSTU MAMI
- Issue: Vol 5, No 2 (2011)
- Pages: 144-149
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/69931
- DOI: https://doi.org/10.17816/2074-0530-69931
- ID: 69931
Cite item
Full Text
Abstract
The paper deals with the problem of accurate determining the area of contact of a tool with a workpiece in the processe of smoothing of outer cylindrical surfaces. As a tool for turning a plate were considered the standard geometry plates (SNMG). The article describes in detail the technique of simulation of contact interaction, the results of the analytical data processing.
Keywords
About the authors
V A Kuznetsov
MSTU MAMI
Email: , vak@mami.ru <mailto:vak@mami.ru>
д.т.н. проф8 (495) 223-05-23, доб. 1219, 1214; МГТУ «МАМИ»; MSTU MAMI
D A Sazonov
MSTU MAMI
Email: , vak@mami.ru <mailto:vak@mami.ru>
8 (495) 223-05-23, доб. 1219, 1214; МГТУ «МАМИ»; MSTU MAMI
A V Smirnov
MSTU MAMI
Email: , vak@mami.ru <mailto:vak@mami.ru>
8 (495) 223-05-23, доб. 1219, 1214; МГТУ «МАМИ»; MSTU MAMI
References
- Кузнецов А.М., Перекатов Ю.А., Кузнецов В.А. Основы системного анализа и структурного синтеза методов изготовления деталей / Кузнецов А.М., Перекатов Ю.А., Кузнецов В.А.//Комплект: инструмент, технология, оборудование. 2007, № 10.- с. 78 - 84
- Кузнецов В.А., Шеставин П.В., Смирнов А.В., Сазонов Д.А. Выглаживание деталей многогранными неперетачиваемыми пластинами. /Автомобильная промышленностью 2010, №10 - с. 24-26
- Кузнецов В.А., Шеставин П.В. Повышение эффективности выглаживания и комбинированной обработки за счет изменения способа установки инструмента.//Известия МГТУ «МАМИ». Научный рецензируемый журнал. 2007, № 2. - с. 174 - 177