Analysis of Formation of Machining Error in the Technological System of Combined Machining and Surface Plastic Deformation of Non-rigid Parts of the Hollow Cylinder Type
- Authors: Vetrova EA1
-
Affiliations:
- MSTU MAMI
- Issue: Vol 5, No 2 (2011)
- Pages: 110-116
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/69895
- DOI: https://doi.org/10.17816/2074-0530-69895
- ID: 69895
Cite item
Full Text
Abstract
On the basis of the study it is revealed that the formation of machining error for non-rigid parts of the hollow cylinder type depends on the errors of an installation, static and dynamic errors in setting the technological system of combined machining and surface plastic deformation.
References
- Анкин А.В. Повышение производительности и качества комбинированной обработки нежестких валов. Дисс. ... к.т.н.,- М., МАМИ, 1993.
- Справочник технолога-машиностроителя. Под ред. Косиловой А.Г., изд. 5-е, - М. Машиностроение, 1985, - Т. 1, 2.
- Максимов Ю.В. Обеспечение качества и производительности обработки нежестких валов применением технологических систем с дополнительными контурами связи. Дисс. ... д.т.н.,- М., МГТУ «МАМИ», 2000.
- Папшев Д.Д. Отделочно-упрочняющая обработка поверхностным пластическим деформированием.- М.: Машиностроение, 1978.- 152 c.
- Справочник металлиста. В 5-ти т. Т.4. Под ред. Новикова М.П. и Орлова П.Н. - М.: Машиностроение, 1977. - 720 с.