Bench assembly for diesel engine tests with water injection in an inlet collector
- Authors: Dmitriev SV1, Khlyupin VB1
-
Affiliations:
- Kamskaya State Engineering-economic Academy
- Issue: Vol 2, No 2 (2008)
- Pages: 255-259
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/69814
- DOI: https://doi.org/10.17816/2074-0530-69814
- ID: 69814
Cite item
Full Text
Abstract
The paper describes the assembly of the motor bench for toxicity, profitability and capacity tests of diesel engine. The authors estimate the thermal balance at water injection in an inlet collector. Recommendations for the choice of devices for measurement of these parameters are given.
Keywords
About the authors
S V Dmitriev
Kamskaya State Engineering-economic Academy
Email: zin_ina@mail.ru
д.т.н., проф; Камская государственная инженерно-экономическая академия (ИНЭКА); Kamskaya State Engineering-economic Academy
V B Khlyupin
Kamskaya State Engineering-economic Academy
Email: zin_ina@mail.ru
Kamskaya State Engineering-economic Academy
References
- Кульчицкий А.Р. Токсичность автомобильных и тракторных двигателей: Учеб.пособие/Владим.гос.ун-т. Владимир, 2000.-256 с.
- Перель Л.Я. Подшипники качения: Расчет, проектирование и обслуживание опор: Справочник.- М.: Машиностроение, 1983.-543 с.
- Райков И.Я. Испытания двигателей внутреннего сгорания. - М.: Высш.шк.,1975.-320 с.
- Хлюпин В.Б. Стенд для исследования показателей дизеля при впрыскивании воды//Проблемы и перспективы развития авиации, наземного транспорта и энергетики «АНТЭ -07»: Материалы международ. научн.-тех. конф. г.Казань, 2007, с.191-194.