Engineering method of calculation of gasdynamic foil bearings of turbocompressors
- Authors: Merkulov V.I1, Plykin M.E1, Tishchenko I.V1,2
-
Affiliations:
- Moscow State University of Mechanical Engineering
- JSC RPO «Nauka»
- Issue: Vol 6, No 2-1 (2012)
- Pages: 279-286
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/68524
- DOI: https://doi.org/10.17816/2074-0530-68524
- ID: 68524
Cite item
Full Text
Abstract
In this article the engineering method of calculation of gasdynamic foil bearings is considered. Calculations according to this method were made and comparison with the experimental results, obtained by other authors, was done. Ranges of application are also considered.
Keywords
Full Text
##article.viewOnOriginalSite##About the authors
V. I Merkulov
Moscow State University of Mechanical Engineering
Email: tgtd@mami.ru
Dr. Eng., prof.
M. E Plykin
Moscow State University of Mechanical Engineering
Email: tgtd@mami.ru
I. V Tishchenko
Moscow State University of Mechanical Engineering; JSC RPO «Nauka»
Email: IV.Tishenko@npo-nauka.ru
Ph.D.
References
- Agrawal. Foil air/gas bearing technology. An overview. ASME, 345E. New York, 1007, publication 97-GT-347
- GT-2003-38606. Development of high-speed industrial turbo blowers with foil air bearing. ASME, Turbo Expo, 2003, USA
- Low-friction wear-resistant coating for high-temperature foil bearings, report N.Y, 12205, USA
- Технические справки и отчеты МГТУ «МАМИ» за 2010-2011гг.
- Ермилов Ю.И. Осевые лепестковые газодинамические подшипники. Диссертация на соискание ученой степени кандидата технических наук, 2008г.