Designing of the technological process for manufacturing of parts based on technical and economic modeling
- Authors: Kuznetsov V.A1, Vladyka A.A1, Tsitrikov A.V1, Zakharova O.Z.1
-
Affiliations:
- Moscow State University of Mechanical Engineering (MAMI)
- Issue: Vol 6, No 2-2 (2012)
- Pages: 112-116
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/68454
- DOI: https://doi.org/10.17816/2074-0530-68454
- ID: 68454
Cite item
Full Text
Abstract
In this article there is considered the problem of finding a method of machining, which has optimal technical and economic parameters such as: basic (machine) time, performance, cost, profit, in close connection with the designing of optimal process.
Full Text
##article.viewOnOriginalSite##About the authors
V. A Kuznetsov
Moscow State University of Mechanical Engineering (MAMI)Dr. Eng., Prof.
A. A Vladyka
Moscow State University of Mechanical Engineering (MAMI)
A. V Tsitrikov
Moscow State University of Mechanical Engineering (MAMI)
O.O. Zakharova Zakharova
Moscow State University of Mechanical Engineering (MAMI)
References
- Кузнецов В.А. Синтез и исследование технологических структур методов механической обработки поверхностей деталей машин. Дисс. докт. техн. наук, М., 2000.
- Этин А.О., Юхвид М.Е. Кинематический анализ и выбор эффективных методов обработки лезвийным инструментом. М., АО ЭНИМС, 1994.
- Дащенко А.И., Белоусов А.П. Проектирование автоматических линий М., Высшая школа, 1983.