Automated calculation of heating power and heating time of a die mold in start-up mode
- Authors: Lyang V.F1
-
Affiliations:
- Moscow State University of Mechanical Engineering (MAMI)
- Issue: Vol 6, No 2-4 (2012)
- Pages: 169-173
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/68409
- DOI: https://doi.org/10.17816/2074-0530-68409
- ID: 68409
Cite item
Full Text
Abstract
This paper describes a software Polymer designed to calculate heating power and heating time of a die mold in start-up mode.
Keywords
Full Text
##article.viewOnOriginalSite##References
- Казанков Ю.В., Макаров М.С., Миронов В.А. Расчет и конструирование формующего инструмента: Лабораторный практикум. – М.: МИХМ, 1992. – 84 с.
- Троелсен Эндрю. Язык программирования С# 2005 и платформа.NET 2.0. - М.: ООО «И.Д. Вильямс», 2007. – 1168 с.