The influence of cutting modes and structural parameters of the device for combined cutting processing and surface plastic deformation on the roughness of the processed surface unstable parts of hollow cylinder type
- Authors: Vetrova E.A1, Lebedev P.A1, Adeev A.S1
-
Affiliations:
- Moscow State University of Mechanical Engineering (MAMI)
- Issue: Vol 7, No 2-2 (2013)
- Pages: 262-267
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/68299
- DOI: https://doi.org/10.17816/2074-0530-68299
- ID: 68299
Cite item
Full Text
Abstract
Cutting modes and structural parameters of the device for combined cutting processing and surface plastic deformation have a significant impact on the roughness of the processed surface unstable parts type hollow cylinder.
Full Text
##article.viewOnOriginalSite##About the authors
E. A Vetrova
Moscow State University of Mechanical Engineering (MAMI)495-223-05-23, ext. 1327
P. A Lebedev
Moscow State University of Mechanical Engineering (MAMI)495-223-05-23, ext. 1327
A. S Adeev
Moscow State University of Mechanical Engineering (MAMI)495-223-05-23, ext. 1327
References
- Анкин А.В. Повышение производительности и качества комбинированной обработки нежестких валов. Дисс.. к.т.н.,- М., МАМИ, 1993.
- Максимов Ю.В. Обеспечение качества и производительности обработки нежестких валов применением технологических систем с дополнительными контурами связи. Дисс.. д.т.н.,- М., МГТУ «МАМИ», 2000.
- Руководящие материалы по размерно-чистовой и упрочняющей обработке поверхностным пластическим деформированием инструментами и устройствами ротационного действия. Москва – ОНТИ – 1966. - 119 с.