Email this article Analysis of microstructure of surface layer of a hole while deforming drawing in lubricants
- Authors: Buylov A.E.1
-
Affiliations:
- Moscow State University of Mechanical Engineering (MAMI)
- Issue: Vol 7, No 1-2 (2013)
- Pages: 20-22
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/67971
- DOI: https://doi.org/10.17816/2074-0530-67971
- ID: 67971
Cite item
Full Text
Abstract
The influence of applied lubricants on formation of a surface layer microstructure while deforming drawing for various materials and technological parameters is considered in this article.
Full Text
##article.viewOnOriginalSite##About the authors
A. E. Buylov
Moscow State University of Mechanical Engineering (MAMI)+7 (495) 223-05-23, ext. 1321
References
- Проскуряков Ю.Г., Романов В.И., Исаев А.Н. Объемное дорнование отверстий. М., Машиностроение, 1984, 222с.
- Розенберг А.М. Физические явления при деформирующем протягивании и резании пластических материалов. Киев, Институт сверхтвердых материалов АН УССР, 1988, 187с.
Supplementary files
