Enhanced algorithm for gear calculation for justified selection of materials of gears and wheels
- Authors: Lukyanov A.S.1, Starikov A.I.1
-
Affiliations:
- Moscow State University of Mechanical Engineering (MAMI)
- Issue: Vol 8, No 1-5 (2014)
- Pages: 194-199
- Section: Articles
- URL: https://journals.rcsi.science/2074-0530/article/view/67563
- DOI: https://doi.org/10.17816/2074-0530-67563
- ID: 67563
Cite item
Full Text
Abstract
This paper proposes a new improved algorithm for gear calculating allowing justified selection of sizes and heat treatment of the material for manufacture of gears and wheels, considering service life and operational mode. On the basis of the proposed algorithm, a program for gear calculation is developed.
Full Text
##article.viewOnOriginalSite##About the authors
A. S. Lukyanov
Moscow State University of Mechanical Engineering (MAMI)
Email: salek61@mail.ru
Ph.D.; +7 495 223-05-23
A. I. Starikov
Moscow State University of Mechanical Engineering (MAMI)
Email: salek61@mail.ru
+7 495 223-05-23
References
- Баловнев Н.П., Пронин Б.А. «Расчет цилиндрических зубчатых передач на прочность» Учебное пособие по дисциплине «Детали машин и основы конструирования» для студентов машиностроительных специальностей. МГТУ «МАМИ», 2006
- Лукьянов А.С., Стариков А.И. К вопросу повышения эффективности расчёта зубчатых и червячных передач. М., Журнал Известия МГТУ «МАМИ», 2013 г.
- Шейнблит А. Е., «Курсовое проектирование деталей машин» Учеб. пособие. Изд-е 2-е, перераб. и дополн., Калининград, 2002. - 454 с.