Calculation of contact parameters of loaded body with outer ring raceway in metalpolymer roller bearing



Cite item

Full Text

Abstract

The method for calculation of contact parameters of loaded body with outer ring raceway in roll- er bearing with polymer coating on outer ring was proposed. The formulas for calculating the pa- rameters of contact were obtained: the width of contact area half-axis and maximum contact stress- es. Computer program for faster and less labor-intensive calculation of contact parameters was de- veloped.

About the authors

R. I Li

Lipetsk State Technical University

Email: romanlee@list.ru
Dr.Eng., Prof.; +7 919 164-61-58

A. V Mironenko

Lipetsk State Technical University

+7 919 164-61-58

References

  1. Ли Р.И., Щетинин М.В., Бутин А.В., Шипулин М.А. Повышение эффективности акрилового адгезива АН-105 при восстановлении неподвижных соединений подшипников качения // Вестник МичГАУ. - 2011. - №1 Ч. 1 - С. 214-217.
  2. Ли Р.И., Машин Д.В. Теоретические аспекты повышения эффективности восстановления корпусных деталей сельскохозяйственной техники композициями на основе эластомеров // Вестник МичГАУ. - 2013. - № 1. - С. 53-55.
  3. Ли Р.И., Кузнецов М.М. Условия передачи нагрузки на боковые тела качения в подшипнике с клеевыми соединением «вал-подшипник» // Наука в центральной России. - 2013. - № 4. - С. 21-25.
  4. Перель Л.Я. Подшипники качения: Расчет, проектирование и обслуживание опор: Справочник. - М.: Машиностроение, 1983. - 543 с., ил.
  5. Курчаткин В.В. Восстановление посадок подшипников качения сельскохозяйственной техники полимерными материалами. - Дис.. док. техн. наук. - М., 1989, - 407с.
  6. Федосьев В.И. Сопротивление материалов. - М.: Наука, 1979. - 544 с.
  7. Chernov N. Fitting geometric curves to observed data. 197 p.

Copyright (c) 2015 Li R.I., Mironenko A.V.

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies