Email this article Experimental and Theoretical Studies of the Mechanical Properties of 3D Printed Polyamide Products of the Schwarz Primitive Topology
- Authors: Arsentev M.Y.1, Balabanov S.V.1, Makogon A.I.1, Sychev M.M.1,2
-
Affiliations:
- Institute of Silicate Chemistry, Russian Academy of Sciences
- St. Petersburg State Institute of Technology (Technical University)
- Issue: Vol 45, No 6 (2019)
- Pages: 599-602
- Section: Short Communication
- URL: https://journals.rcsi.science/1087-6596/article/view/217776
- DOI: https://doi.org/10.1134/S1087659619060026
- ID: 217776
Cite item
Open Access
Access granted
Subscription Access
Abstract
Polyamide-12 products based on the Schwarz primitive topology with different values of parameter t are created by 3D printing. The samples are obtained by selective laser sintering using an EOS 3D printer. The experimental stress–strain curves are obtained. It is revealed that as parameter t increases the strength of the samples decreases. Computer simulation using the COMSOL Multiphysics software is performed.
About the authors
M. Yu. Arsentev
Institute of Silicate Chemistry, Russian Academy of Sciences
Author for correspondence.
Email: ars21031960@gmail.com
Russian Federation, St. Petersburg, 199034
S. V. Balabanov
Institute of Silicate Chemistry, Russian Academy of Sciences
Email: ars21031960@gmail.com
Russian Federation, St. Petersburg, 199034
A. I. Makogon
Institute of Silicate Chemistry, Russian Academy of Sciences
Email: ars21031960@gmail.com
Russian Federation, St. Petersburg, 199034
M. M. Sychev
Institute of Silicate Chemistry, Russian Academy of Sciences; St. Petersburg State Institute of Technology (Technical University)
Email: ars21031960@gmail.com
Russian Federation, St. Petersburg, 199034; St. Petersburg, 190013
Supplementary files
