Email this article Design Engineering of Refractory Components for Use in Refining Continuous-Cast Steel
- Authors: Neunyvakhina D.T.1, Chislavlev V.V.1, Feiler S.V.1, Boikov D.V.2
-
Affiliations:
- Siberian State Industrial University Federal State-Funded Institution of Higher Education
- EVRAZ Joint West Siberian Metallurgical Complex
- Issue: Vol 58, No 6 (2018)
- Pages: 603-607
- Section: Refractories in Heating Units
- URL: https://journals.rcsi.science/1083-4877/article/view/248936
- DOI: https://doi.org/10.1007/s11148-018-0153-0
- ID: 248936
Cite item
Open Access
Access granted
Subscription Access
Abstract
We perform physical and mathematical modeling of tundish hydrodynamic processes in the 4-strand continuous bloom casting machine at the EVRAZWest Siberian Metallurgical Complex. Aphysical model of the tundish is used for qualitative assessment of melt mixing processes. A qualitative assessment of nonmetallic inclusion removal efficiency in the tundish is provided for models that employ refractory components in a variety of different configurations. We develop recommended design parameters for full-height refractory dividers in the tundish.
About the authors
D. T. Neunyvakhina
Siberian State Industrial University Federal State-Funded Institution of Higher Education
Email: chisl.vv@yandex.ru
Russian Federation, Novokuznetsk
V. V. Chislavlev
Siberian State Industrial University Federal State-Funded Institution of Higher Education
Author for correspondence.
Email: chisl.vv@yandex.ru
Russian Federation, Novokuznetsk
S. V. Feiler
Siberian State Industrial University Federal State-Funded Institution of Higher Education
Email: chisl.vv@yandex.ru
Russian Federation, Novokuznetsk
D. V. Boikov
EVRAZ Joint West Siberian Metallurgical Complex
Email: chisl.vv@yandex.ru
Russian Federation, Novokuznetsk
Supplementary files
