Email this article Specialized numerical control system for five-axis planing and milling center
- Authors: Martinov G.M.1, Kozak N.V.1
-
Affiliations:
- STANKIN Moscow State Technological University
- Issue: Vol 36, No 3 (2016)
- Pages: 218-222
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/226244
- DOI: https://doi.org/10.3103/S1068798X16030126
- ID: 226244
Cite item
Open Access
Access granted
Subscription Access
Abstract
The architecture and design features of the numerical control system for an E7106MF4 machining center are considered. This system permits five-axis machining by three-dimensional planing. Organization of the automatic electrical automation subsystem is discussed. Practical aspects of the control system are presented.
About the authors
G. M. Martinov
STANKIN Moscow State Technological University
Author for correspondence.
Email: martinov@ncsystems.ru
Russian Federation, Moscow, 127055
N. V. Kozak
STANKIN Moscow State Technological University
Email: martinov@ncsystems.ru
Russian Federation, Moscow, 127055
Supplementary files
