Control of Electron-Beam Surfacing-Process Parameters Using Current Signals of the Wire and Article

详细

This paper presents a method of control of the metal-transfer mode during electron-beam surfacing with a filler-wire feed based on simultaneous recording of the potential of the wire and article connected with the apparatus frame through the resistors. The main metal-transfer modes are specified that are observed with a change of the energy-input rate. The importance of the solved problem for additive technologies is shown. A scheme of experimental investigations carried out at the ELA-15I apparatus is given, and the obtained oscillograms are presented. The relation of the characteristics of the registered signals with the operation modes of the equipment and transfer parameters is shown. It is noted that, with a change of only the filler-wire feed rate, a changeover from drop metal transfer to the scattering mode can be triggered. The possibility of detecting the mode of appearance of the shot metal, as well as emergency modes related with stopping the filler-wire feed or excessive increase of its feed rate, is substantiated. The influence of the plasma processes on the registered signals in the developed scheme is analyzed, and it is also shown that, to reduce the influence of these processes, it is necessary to decrease the resistance of the measuring circuit. Photographs of the process corresponding to the certain oscillogram intervals are given.