Using nondestructive testing methods for in-production quality control of additive manufactured parts
- Autores: Aleshin N.1, Grigor’ev M.1, Shchipakov N.1, Prilutskii M.1, Murashov V.1
-
Afiliações:
- Scientific-Research Center “Welding and Monitoring”
- Edição: Volume 52, Nº 9 (2016)
- Páginas: 532-537
- Seção: General Problems of Nondestructive Testing
- URL: https://journals.rcsi.science/1061-8309/article/view/181186
- DOI: https://doi.org/10.1134/S1061830916090023
- ID: 181186
Citar
Resumo
Peculiarities of additive technologies are considered, and the most typical flaws are listed. The possibility of layer-by-layer nondestructive testing of parts immediately in the course of additive manufacturing is demonstrated. Based on the review of domestic and international publications, possibilities that are offered by various physical methods of nondestructive evaluation are analyzed and potential of their usage is reviewed.
Palavras-chave
Sobre autores
N. Aleshin
Scientific-Research Center “Welding and Monitoring”
Autor responsável pela correspondência
Email: aleshin@bmstu.ru
Rússia, Moscow, 105005
M. Grigor’ev
Scientific-Research Center “Welding and Monitoring”
Email: aleshin@bmstu.ru
Rússia, Moscow, 105005
N. Shchipakov
Scientific-Research Center “Welding and Monitoring”
Email: aleshin@bmstu.ru
Rússia, Moscow, 105005
M. Prilutskii
Scientific-Research Center “Welding and Monitoring”
Email: aleshin@bmstu.ru
Rússia, Moscow, 105005
V. Murashov
Scientific-Research Center “Welding and Monitoring”
Email: aleshin@bmstu.ru
Rússia, Moscow, 105005