Using nondestructive testing methods for in-production quality control of additive manufactured parts

N. P. Aleshin; M. V. Grigor’ev; N. A. Shchipakov; M. A. Prilutskii; V. V. Murashov

doi:10.1134/S1061830916090023

Using nondestructive testing methods for in-production quality control of additive manufactured parts

Authors: Aleshin N.P.¹, Grigor’ev M.V.¹, Shchipakov N.A.¹, Prilutskii M.A.¹, Murashov V.V.¹
Affiliations:
1. Scientific-Research Center “Welding and Monitoring”
Issue: Vol 52, No 9 (2016)
Pages: 532-537
Section: General Problems of Nondestructive Testing
URL: https://journals.rcsi.science/1061-8309/article/view/181186
DOI: https://doi.org/10.1134/S1061830916090023
ID: 181186

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Statistics

Abstract

Peculiarities of additive technologies are considered, and the most typical flaws are listed. The possibility of layer-by-layer nondestructive testing of parts immediately in the course of additive manufacturing is demonstrated. Based on the review of domestic and international publications, possibilities that are offered by various physical methods of nondestructive evaluation are analyzed and potential of their usage is reviewed.