Email this article Producing Structural-Steel Bar from Continuous-Cast Billet
- Authors: Smirnov A.N.1, Smirnov E.N.2, Sklyar V.A.2, Belevitin V.A.3, Pivovarov R.E.2
-
Affiliations:
- Physical and Technological Institute of Metals and Alloys
- Stary Oskol Branch
- South Ural State Humanitarian and Pedagogical University
- Issue: Vol 48, No 4 (2018)
- Pages: 233-239
- Section: Article
- URL: https://journals.rcsi.science/0967-0912/article/view/180077
- DOI: https://doi.org/10.3103/S0967091218040113
- ID: 180077
Cite item
Open Access
Access granted
Subscription Access
Abstract
The expanded use of continuous-cast billet in the production of structural-steel bar is considered. The quality of 135 × 135 mm continuous-cast billet produced on a standard continuous-casting machine and the bar derived from it is evaluated. At more recently built plants, the production of quality bar from continuous- cast billet requires total extension of the order of 6–7. On the basis of the analysis developed in the present work, it is possible to determine the maximum critical bar cross section such that the required properties are ensured.
About the authors
A. N. Smirnov
Physical and Technological Institute of Metals and Alloys
Author for correspondence.
Email: stalevoz@i.ua
Ukraine, Kiev
E. N. Smirnov
Stary Oskol Branch
Email: stalevoz@i.ua
Russian Federation, Stary Oskol
V. A. Sklyar
Stary Oskol Branch
Email: stalevoz@i.ua
Russian Federation, Stary Oskol
V. A. Belevitin
South Ural State Humanitarian and Pedagogical University
Email: stalevoz@i.ua
Russian Federation, Chelyabinsk
R. E. Pivovarov
Stary Oskol Branch
Email: stalevoz@i.ua
Russian Federation, Stary Oskol
