Providing the Uniformity of Measurements of the Thickness of Metallic Coatings by Eddy-Current Phase Thickness Gages During Their Calibration and Verification
- Authors: Golubev S.S.1, Smirnova N.I.2, Skladanovskaya M.I.3
-
Affiliations:
- Federal Agency for Technical Regulation and Metrology ROSSTANDART
- Mendeleev All-Russia Research Institute of Metrology (VNIIM)
- St. Petersburg Mining University
- Issue: Vol 60, No 6 (2017)
- Pages: 552-557
- Section: Article
- URL: https://journals.rcsi.science/0543-1972/article/view/246188
- DOI: https://doi.org/10.1007/s11018-017-1233-0
- ID: 246188
Cite item
Abstract
Problems of providing uniformity of measurements of the thickness of metallic coatings by the eddy-current phase method are examined. The physical principles of the method as well as the design and metrological characteristics of the measuring instruments are analyzed. The dependences of the error of measuring the thickness of metallic coatings on the influencing parameters during graduation, verification, and calibration are obtained. The requirements imposed on the electrophysical parameters of metallic coating thickness standards are formulated.
About the authors
S. S. Golubev
Federal Agency for Technical Regulation and Metrology ROSSTANDART
Author for correspondence.
Email: golubev@gost.ru
Russian Federation, Moscow
N. I. Smirnova
Mendeleev All-Russia Research Institute of Metrology (VNIIM)
Email: golubev@gost.ru
Russian Federation, St. Petersburg
M. I. Skladanovskaya
St. Petersburg Mining University
Email: golubev@gost.ru
Russian Federation, St. Petersburg