Iterative Method of Adjusting the Radius of the Spherical Probe of Mobile Coordinate-Measuring Machines When Monitoring a Rotation Surface
- Authors: Grechnikov F.V.1, Rezchikov A.F.2, Zakharov O.V.3
-
Affiliations:
- Korolev Samara National Research University
- Institute of Problems of Precision Mechanics and Control, Russian Academy of Sciences
- Gagarin Saratov State Technical University
- Issue: Vol 61, No 4 (2018)
- Pages: 347-352
- Section: Linear and Angular Measurements
- URL: https://journals.rcsi.science/0543-1972/article/view/246453
- DOI: https://doi.org/10.1007/s11018-018-1432-3
- ID: 246453
Cite item
Abstract
An iterative method of probe radius compensation of mobile coordinate-measuring machines when controlling bodies of rotation is examined. The new method minimizes the angle between the normals at the specified point to the nominal and actual profiles as a result of successive approximations. Results of measurement and data handling showed high efficiency of the iterative method by comparison with known methods that are based on the least squares method. The greatest effect on reducing the error of probe radius compensation is reached with a small number of measured points and their non-uniform arrangement on the surface of the component part.
About the authors
F. V. Grechnikov
Korolev Samara National Research University
Email: zov20@mail.ru
Russian Federation, Samara
A. F. Rezchikov
Institute of Problems of Precision Mechanics and Control, Russian Academy of Sciences
Email: zov20@mail.ru
Russian Federation, Saratov
O. V. Zakharov
Gagarin Saratov State Technical University
Author for correspondence.
Email: zov20@mail.ru
Russian Federation, Saratov