Model of influence of a rope defect on the spectrum of its free transverse vibrations

Cover Page

Cite item

Full Text

Open Access Open Access
Restricted Access Access granted
Restricted Access Subscription Access

Abstract

In earlier work the possibility of diagnosing a defect of a steel wire rope by spectral composition of its free transverse vibrations was substantiated. In the present work, an analytical model of transverse vibrations of a steel wire rope with local damage is proposed. The presence of the defect in the model is taken into account only in the form of a loss of bending stiffness of the corresponding section without changing the specific mass along the length. The model represents three homogeneous rope sections “stitched” together, where the middle one represents a defective section with a lower value of bending stiffness. According to the model calculations, it is shown that the character of the dependence of the natural frequencies of oscillations on their number practically does not change in the presence of a defect. However, its presence and location affects the ratio of vibration amplitudes of undamaged sections, which can be used to monitor the condition of the rope.

About the authors

K. R Muratov

Industrial University of Tyumen

Email: muratows@mail.ru
Tyumen, Russia

I. A Sharopina

Industrial University of Tyumen

Email: sharopinaia@gmail.com
Tyumen, Russia

I. S Bevzyuk

Industrial University of Tyumen

Email: ira29019@gmail.com
Tyumen, Russia

R. A Sokolov

Industrial University of Tyumen

Email: falcon.rs@mail.ru
Tyumen, Russia

V. V Probotyuk

Industrial University of Tyumen

Email: probotjukvv@tyuiu.ru
Tyumen, Russia

References

  1. Осипов С.П., Батранин А.В., Воронова В.С., Шиндина А.В. Идентификация дефектов стальных канатов по цифровым радиографическим изображениям // Технологии техносферной безопасности. 2013. № 5(51). С. 6.
  2. Lei H. M., Mao Yi.M. Fatigue Testing and evaluation for coated steel belts based on electrical method // Дефектоскопия. 2013. № 10. С. 53-60.
  3. Соболев А.С., Пудов В.И. Физическое моделирование условий и параметров надежности магнитного контроля стальных канатов // Дефектоскопия. 2014. № 11. С. 22-30.
  4. Сухоруков В.В. Техническая диагностика стальных канатов добывающей промышленности: от дефектоскопии к автоматизированному мониторингу // В мире неразрушающего контроля. 2019. Т. 22. № 3. С. 4-8.
  5. Муратов К.Р., Новиков В.Ф., Кулак С.М., Соколов Р.А., Сафаргалиев Р.Ф., Мусихин С.А., Проботюк В.В. Учет жесткости стальных канатов при оценке силы их натяжения по результатам измерения частоты собственных колебаний // Дефектоскопия. 2023. № 2. С. 16-23.

Copyright (c) 2023 Russian Academy of Sciences

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies