State of Stress in Cylindrical Parts during Transverse Straightening
- 作者: Zaides S.1, Le Hong Quang 1
-
隶属关系:
- Irkutsk National Technical University
- 期: 卷 2019, 编号 13 (2019)
- 页面: 1487-1491
- 栏目: Machining of Blanks and Assembly
- URL: https://journals.rcsi.science/0036-0295/article/view/173901
- DOI: https://doi.org/10.1134/S003602951913041X
- ID: 173901
如何引用文章
详细
Straightening by transverse bending followed by hardening by surface plastic deformation based on transverse spinning of cylindrical parts by flat plates is suggested to restore the shape of distorted low-rigidity cylindrical parts, such as shafts and axles. The Ansys Workbench software package is used to estimate the state of stress in a cylindrical part during transverse straightening. The distributions of the working and residual stresses over the cross section of a cylinder are obtained as a function of the relative reduction.
作者简介
S. Zaides
Irkutsk National Technical University
编辑信件的主要联系方式.
Email: zsa@istu.edu
俄罗斯联邦, Irkutsk, 664074
Le Hong Quang
Irkutsk National Technical University
Email: zsa@istu.edu
俄罗斯联邦, Irkutsk, 664074