State of Stress in Cylindrical Parts during Transverse Straightening
- Autores: Zaides S.1, Le Hong Quang 1
-
Afiliações:
- Irkutsk National Technical University
- Edição: Volume 2019, Nº 13 (2019)
- Páginas: 1487-1491
- Seção: Machining of Blanks and Assembly
- URL: https://journals.rcsi.science/0036-0295/article/view/173901
- DOI: https://doi.org/10.1134/S003602951913041X
- ID: 173901
Citar
Resumo
Straightening by transverse bending followed by hardening by surface plastic deformation based on transverse spinning of cylindrical parts by flat plates is suggested to restore the shape of distorted low-rigidity cylindrical parts, such as shafts and axles. The Ansys Workbench software package is used to estimate the state of stress in a cylindrical part during transverse straightening. The distributions of the working and residual stresses over the cross section of a cylinder are obtained as a function of the relative reduction.
Sobre autores
S. Zaides
Irkutsk National Technical University
Autor responsável pela correspondência
Email: zsa@istu.edu
Rússia, Irkutsk, 664074
Le Hong Quang
Irkutsk National Technical University
Email: zsa@istu.edu
Rússia, Irkutsk, 664074
![](/img/style/loading.gif)