Application of Thickness-Shaped Workpieces to Control the Wall Thickness of Lead-Formed Shell Parts
- Autores: Baburin M.1, Baskakov V.1, Zarubina O.1, Ladov S.1, Nikol’skaya Y.1, Fedorov S.1
-
Afiliações:
- Bauman Moscow State Technical University
- Edição: Volume 2017, Nº 13 (2017)
- Páginas: 1136-1140
- Seção: Metal Forming
- URL: https://journals.rcsi.science/0036-0295/article/view/171933
- DOI: https://doi.org/10.1134/S0036029517130031
- ID: 171933
Citar
Resumo
The influence of the geometric parameters of variable-thickness steel disk workpieces on the wall thickness of cylindrical shell parts with a spherical bottom, which are produced by lead stamping, is experimentally studied. The found laws of changing the dome thickness and the edge thickness of stamped parts allowed us to make recommendations for designing the lead stamping of such parts with a given wall thickness distribution.
Palavras-chave
Sobre autores
M. Baburin
Bauman Moscow State Technical University
Email: baskakov_vd@mail.ru
Rússia, Moscow
V. Baskakov
Bauman Moscow State Technical University
Autor responsável pela correspondência
Email: baskakov_vd@mail.ru
Rússia, Moscow
O. Zarubina
Bauman Moscow State Technical University
Email: baskakov_vd@mail.ru
Rússia, Moscow
S. Ladov
Bauman Moscow State Technical University
Email: baskakov_vd@mail.ru
Rússia, Moscow
Ya. Nikol’skaya
Bauman Moscow State Technical University
Email: baskakov_vd@mail.ru
Rússia, Moscow
S. Fedorov
Bauman Moscow State Technical University
Email: baskakov_vd@mail.ru
Rússia, Moscow