Technology of Borating Hardening of the Chaff-Cutter Drum Knives in a Grain Harvester Combine
- Autores: Lyalyakin V.1, Aulov V.1, Ishkov A.2, Trokhin A.3, Slinko D.4
-
Afiliações:
- FGBNU Federal Scientific Agroengineering Center VIM
- Altai State Agrarian University
- OOO Combine Plant ROSTSEL’MASh
- Bauman Moscow State Technical University
- Edição: Volume 2019, Nº 13 (2019)
- Páginas: 1492-1496
- Seção: Physical Metallurgy. Thermal and Thermochemical Treatment Technologies
- URL: https://journals.rcsi.science/0036-0295/article/view/173904
- DOI: https://doi.org/10.1134/S0036029519130202
- ID: 173904
Citar
Resumo
The methods of hardening of the chaff-cutter drum knives in a grain harvester combine are analyzed. The wear resistances of 65g steel samples hardened by quenching and borating and heating by high-frequency currents are compared. The results of field tests of the hardened knives are presented. These results are used to propose a design for a hardening coating. A two-coil induction heater is suggested for simultaneous heating of both face edges of a knife.
Palavras-chave
Sobre autores
V. Lyalyakin
FGBNU Federal Scientific Agroengineering Center VIM
Autor responsável pela correspondência
Email: valpal-1938@mail.ru
Rússia, Moscow
V. Aulov
FGBNU Federal Scientific Agroengineering Center VIM
Email: valpal-1938@mail.ru
Rússia, Moscow
A. Ishkov
Altai State Agrarian University
Email: valpal-1938@mail.ru
Rússia, Barnaul
A. Trokhin
OOO Combine Plant ROSTSEL’MASh
Email: valpal-1938@mail.ru
Rússia, Rostov-on-Don
D. Slinko
Bauman Moscow State Technical University
Email: valpal-1938@mail.ru
Rússia, Moscow