Email this article Effect of Temperature on the Porosity of the Additive Products Made of the Dispersed Wastes of Cobalt–Chromium Alloys
- Authors: Latypov R.A.1, Ageev E.V.2, Altukhov A.Y.2, Ageeva E.V.2
-
Affiliations:
- Moscow Polytechnic University
- Southwest State University
- Issue: Vol 2019, No 12 (2019)
- Pages: 1300-1303
- Section: Resource Saving
- URL: https://journals.rcsi.science/0036-0295/article/view/173771
- DOI: https://doi.org/10.1134/S0036029519120139
- ID: 173771
Cite item
Open Access
Access granted
Subscription Access
Abstract
The additive articles made from the powders fabricated by electric discharge dispersion of the wastes of cobalt–chromium alloys are studied. These articles are shown to have a fine-grained structure without inclusions and discontinuities, and their porosity decreases with increasing fusion temperature. An increase in the fusion temperature 120°C in the temperature range under study is found to decrease the porosity of the articles by a factor of 4.5.
About the authors
R. A. Latypov
Moscow Polytechnic University
Author for correspondence.
Email: latipov46@mail.ru
Russian Federation, Moscow, 115280
E. V. Ageev
Southwest State University
Email: latipov46@mail.ru
Russian Federation, Kursk, 305040
A. Yu. Altukhov
Southwest State University
Email: latipov46@mail.ru
Russian Federation, Kursk, 305040
E. V. Ageeva
Southwest State University
Email: latipov46@mail.ru
Russian Federation, Kursk, 305040
