Email this article Machining of Machine Elements Made of Polymer Composite Materials
- Authors: Baurova N.I.1, Makarov K.A.1
-
Affiliations:
- Moscow Automobile and Road Construction State Technical University (MADI)
- Issue: Vol 2017, No 13 (2017)
- Pages: 1141-1144
- Section: Machining of Blanks and Assembly
- URL: https://journals.rcsi.science/0036-0295/article/view/171935
- DOI: https://doi.org/10.1134/S0036029517130043
- ID: 171935
Cite item
Open Access
Access granted
Subscription Access
Abstract
The machining of the machine elements that are made of polymer composite materials (PCMs) or are repaired using them is considered. Turning, milling, and drilling are shown to be most widely used among all methods of cutting PCMs. Cutting conditions for the machining of PCMs are presented. The factors that most strongly affect the roughness parameters and the accuracy of cutting PCMs are considered.
About the authors
N. I. Baurova
Moscow Automobile and Road Construction State Technical University (MADI)
Author for correspondence.
Email: nbaurova@mail.ru
Russian Federation, Moscow
K. A. Makarov
Moscow Automobile and Road Construction State Technical University (MADI)
Email: nbaurova@mail.ru
Russian Federation, Moscow
