Dynamic Regimes of Biaxial Stretching of a Thin Ideally Rigid-Plastic Rectangular Plate

Мұқаба

Дәйексөз келтіру

Толық мәтін

Ашық рұқсат Ашық рұқсат
Рұқсат жабық Рұқсат берілді
Рұқсат жабық Тек жазылушылар үшін

Аннотация

The stress-strain state arising during dynamic tension of a homogeneous rectangular plate of an incompressible ideally rigid-plastic material, which obeys the Mises–Hencky criterion, is considered. The upper and lower bases are stress-free, longitudinal velocities are set at the ends. The possibility of deformation of the upper and lower sides of the plate is taken into account, which simulates neck formation and further development of the neck. A small geometric parameter is introduced – the ratio of the average thickness of the plate to its length along one of the directions. At different time intervals, the order of smallness of the dimensionless functions characterizing the dynamic stretching mode may be different with respect to the geometric parameter, which determines one or another stretching mode. Two such characteristic modes have been identified, one is associated with a sufficiently high rate of removal of the ends of the plate from each other, the second with acceleration. In the second case, an analysis was carried out using the method of asymptotic integration, which allows us to approximately find the parameters of the stress-strain state.

Авторлар туралы

I. Tsvetkov

Lomonosov Moscow State University

Хат алмасуға жауапты Автор.
Email: cvetkoviv@yandex.ru
Russia, Moscow

Әдебиет тізімі

  1. Zadoyan M.A. Spatial Problems of Plasticity Theory. Moscow: Nauka, 1992. 384 p. (in Russian)
  2. Radaev Y.N. Spatial Problem of Mathematical Theory of Plasticity. Samara: Izd-vo Samar. Gos. Univ., 2004. 147 p. (in Russian)
  3. Annin B.D., Bytev V.O., Senashov S.I., Group Properties of the Equations of Elasticity and Plasticity. Novosibirsk: Nauka, 1985. 239 p. (in Russian)
  4. Senashov S.I., Savostyanova I.L. New solutions of dynamical equations of ideal plasticity // J. Appl.&Industr. Math., 2019, vol. 13, pp. 740–745.
  5. Senashov S.I., Savostyanova I.L. et al. New classes of solutions of dynamical problems of plasticity // J. Sib. Fed. Univ. Math.&Phys., 2020, vol. 13 (6), pp. 792–796.
  6. Shenoy V.B., Freund L.B. Necking bifurcations during high strain rate extension // J. Mech.&Phys. of Solids, 1999, vol. 47, pp. 2209–2233.
  7. Mercier S., Molinari A. Predictions of bifurcation and instabilities during dynamic extension // Int. J. Solids Struct., 2003, viol. 40, pp. 1995–2016.
  8. Tsvetkov I.M. Dynamic tension of a sheet made of rigid-plastic material // Bull. MSU. Mech., 2022, vol. 77, no. 6, pp. 177–185.
  9. Georgievskii D.V. Dynamic tension of a rod made of an ideally rigid-plastic material // J. Appl. Mech.&Tech. Phys., 2021, vol. 62, pp. 806–815.
  10. Tsvetkov I.M. Dynamic axisymmetric tension of a thin round ideally rigid-plastic layer // Mech. Solids, 2023. (in Press)
  11. Taha F., Graf A., Hosford W. Plane-strain tension tests on aluminum aloy sheet // J. Eng. Mater. Technol. (Trans. ASME), 1995, vol. 117, no. 2, pp. 168–171.
  12. Georgievskii D.V., Muller W.H., Abali B.E. Thin-layer inertial effects in plasticity and dynamics in the Prandtl problem // ZAMM Zeitschrift fur Angewandte Mathematik und Mechanik, 2019, vol. 99, no. 12, pp. 1–11.
  13. Nayfeh A.H. Introduction to Perturbation Techniques. N.Y.: Wiley, 1981.

© И.М. Цветков, 2023

Осы сайт cookie-файлдарды пайдаланады

Біздің сайтты пайдалануды жалғастыра отырып, сіз сайттың дұрыс жұмыс істеуін қамтамасыз ететін cookie файлдарын өңдеуге келісім бересіз.< / br>< / br>cookie файлдары туралы< / a>