Effect of roll-bonding temperature on the strength and electrical conductivity of an α-brass-clad Cu–1Cr alloy composite

Resumo

Tri-layered α-brass-clad Cu–Cr-alloy composite plates were prepared by hot roll-bonding. Neither intermetallic-compound layers nor interface defects were observed at the interfaces in the as-rolled and heat-treated α-brass-clad Cu–Cr composite plates. The hardness of the as-rolled α-brass layer was greater than that of the Cu–Cr substrate, since the α-brass was strengthened by strain hardening more efficiently upon rolling. The hardness of the α-brass decreased appreciably upon annealing because of the recovery processes, whereas that of the Cu–Cr layer slightly increased after heat treatment at 450°C due to the precipitation strengthening. After the post-roll-bonding heat treatment at 450°C, the strength of the α-brass-clad Cu–Cr-alloy composite decreased with a significant increase in ductility. The electrical conductivity of the asroll-bonded α-brass clad Cu–Cr alloy composite (47–52% IACS) increased significantly (to 72–74% IACS) after the 1-h heat treatment. The strength and conductivity of the clad composite are dependent on the precipitation strengthening of Cu–Cr and recovery softening of α-brass in the course of the post-roll-bonding heat treatment.