Email this article Combined Technology of Aluminum Alloy Vertical Casting and Simultaneous Deformation
- Authors: Sergeeva A.M.1,2, Lovizin N.S.1, Sosnin A.A.1
-
Affiliations:
- Institute of Engineering and Metallurgy, Far Eat Branch of the Russian Academy of Sciences
- Institute of Scientific and Technical Innovation (Skolkovo Project participant)
- Issue: Vol 62, No 3-4 (2018)
- Pages: 270-274
- Section: Article
- URL: https://journals.rcsi.science/0026-0894/article/view/241610
- DOI: https://doi.org/10.1007/s11015-018-0655-5
- ID: 241610
Cite item
Open Access
Access granted
Subscription Access
Abstract
Technology is developed combining continuous vertical casting of metals with simultaneous deformation, and the device operating principle and implementation of this technology are described. Data are provided for the design features and functioning of the device. Results of experimental studies of AD0 and D16 alloy billets are provided. It is shown that this technology makes it possible in a short production cycle to prepare long metal objects at a rate of 2 m/min. The blanks obtained exhibit a fine-grained structure with a grain size not exceeding 7 μm, and also increased hardness, inferior to the maximum possible by 23%.
About the authors
A. M. Sergeeva
Institute of Engineering and Metallurgy, Far Eat Branch of the Russian Academy of Sciences; Institute of Scientific and Technical Innovation (Skolkovo Project participant)
Author for correspondence.
Email: serg-nasty@mail.ru
Russian Federation, Komsomolsk-on-Amur; Komsomolsk-on-Amur
N. S. Lovizin
Institute of Engineering and Metallurgy, Far Eat Branch of the Russian Academy of Sciences
Email: serg-nasty@mail.ru
Russian Federation, Komsomolsk-on-Amur
A. A. Sosnin
Institute of Engineering and Metallurgy, Far Eat Branch of the Russian Academy of Sciences
Email: serg-nasty@mail.ru
Russian Federation, Komsomolsk-on-Amur
Supplementary files
