Study of Metal Strained State During Workpiece Reduction in a Three-Roll Screw-Rolling Mill

详细

Results are given for a study of metal deformation state with screw rolling in a three-roll mill by means of computer modeling. Quantitative characteristics are obtained for the unequal distribution of degree of deformation through a workpiece cross section. Features are established for the use of screw line pitch length, partial reduction, and penetration index for the plastic deformation zone to workpiece axis in relation to screw line pitch number. Recommendations are given according to which in calculating roll calibration the roll profi le should be selected so that deformation penetrates the whole workpiece depth over the whole deformation site length.