Email this article Modeling Stamping to Determine the Impact Energy of the Hammer and the Locations Where Defects Form
- Authors: Shlyapugin A.G.1, Zamotaev K.S.1
-
Affiliations:
- Samara State Aerospace University (National Research University)
- Issue: Vol 60, No 1-2 (2016)
- Pages: 131-135
- Section: Article
- URL: https://journals.rcsi.science/0026-0894/article/view/238091
- DOI: https://doi.org/10.1007/s11015-016-0262-2
- ID: 238091
Cite item
Open Access
Access granted
Subscription Access
Abstract
The operation of stamping is modeled in the software suite DEFORM-3D to determine the impact energy required of the hammer to completely fill the die in a single impact. The flow of the metal during stamping is analyzed and the probability of defect formation is estimated.
About the authors
A. G. Shlyapugin
Samara State Aerospace University (National Research University)
Author for correspondence.
Email: alex_shag@mail.ru
Russian Federation, Samara
K. S. Zamotaev
Samara State Aerospace University (National Research University)
Email: alex_shag@mail.ru
Russian Federation, Samara
Supplementary files
