Investigation of the Structure and Hardness of Quenched Sintered Materials Produced from Iron-Base Alloyed Powders (Astaloy E)
- 作者: Ostovan F.1, Matori K.A.1,2, Yusoff H.M.3, Yunus R.3, Ariff A.H.4, Toozandehjani M.4, Meschian M.R.5
-
隶属关系:
- Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang
- Department of Physics, Faculty of Science, University Putra Malaysia
- Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
- Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
- Department of Material Engineering, Faculty of Engineering, Islamic Azad University of Majlesi
- 期: 卷 58, 编号 7-8 (2016)
- 页面: 431-434
- 栏目: Article
- URL: https://journals.rcsi.science/0026-0673/article/view/235009
- DOI: https://doi.org/10.1007/s11041-016-0030-8
- ID: 235009
如何引用文章
详细
The effect of heat treatment on the microstructure, hardness and density of sintered (1129°C, 45 min) specimens of iron-base powder alloys containing 0.8 – 2.5% C, 2% Cu and additives of chromium- and molybdenum-alloyed Astaloy E iron powder is studied.
作者简介
Farhad Ostovan
Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang
Email: petroprom2013@yandex.ru
马来西亚, Selangor
Khamirul Matori
Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang; Department of Physics, Faculty of Science, University Putra Malaysia
Email: petroprom2013@yandex.ru
马来西亚, Selangor; Serdang, Selangor
Hamdan Yusoff
Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
马来西亚, Serdang, Selangor
Robiah Yunus
Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
马来西亚, Serdang, Selangor
Azmah Ariff
Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
马来西亚, Serdang, Selangor
Meysam Toozandehjani
Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
马来西亚, Serdang, Selangor
Mohammad Meschian
Department of Material Engineering, Faculty of Engineering, Islamic Azad University of Majlesi
Email: petroprom2013@yandex.ru
伊朗伊斯兰共和国, Isfahan
补充文件
