Mathematical Modeling of the Geometric Dimensions of Flexible Tanks for Oil Products
- Authors: Rybakov Y.N.1, Larionov S.V.1, Chirikov S.I.1, Kyunnap R.I.1
-
Affiliations:
- Federal Aviation Administration – 25 State Scientific Research Institute of Chemmotology of the Ministry of Defense of Russia
- Issue: Vol 51, No 6 (2016)
- Pages: 636-639
- Section: Article
- URL: https://journals.rcsi.science/0009-3092/article/view/234272
- DOI: https://doi.org/10.1007/s10553-016-0652-y
- ID: 234272
Cite item
Abstract
This article describes theoretical approaches to optimizing the geometric dimensions of flexible tanks for oil products with allowance for the total length of the welds on the top and bottom surfaces of the tanks. An algorithm, mathematical models, and an optimization criterion are proposed, making it possible to significantly (by up to 20%) improve the efficiency with which the structural material is laid out and cut. Formulas are given for determining the optimal height, length, and width of the flexible tanks.
About the authors
Yu. N. Rybakov
Federal Aviation Administration – 25 State Scientific Research Institute of Chemmotology of the Ministry of Defense of Russia
Author for correspondence.
Email: ribakov61@mail.ru
Russian Federation, Moscow
S. V. Larionov
Federal Aviation Administration – 25 State Scientific Research Institute of Chemmotology of the Ministry of Defense of Russia
Email: ribakov61@mail.ru
Russian Federation, Moscow
S. I. Chirikov
Federal Aviation Administration – 25 State Scientific Research Institute of Chemmotology of the Ministry of Defense of Russia
Email: ribakov61@mail.ru
Russian Federation, Moscow
R. I. Kyunnap
Federal Aviation Administration – 25 State Scientific Research Institute of Chemmotology of the Ministry of Defense of Russia
Email: ribakov61@mail.ru
Russian Federation, Moscow
Supplementary files
