Email this article Influence of Capillary-Porous Coatings on Heat Exchanger Efficiency
- Authors: Gusev V.M.1, Buklakov A.G.1, Konovalov P.A.2, Tyuftyaev A.S.2
-
Affiliations:
- Russian State University of Oil and Gas (Rossiiskii Gosudarstvennyi Universitet Nefti i Gaza)
- Joint Institute for High Temperatures, Russian Academy of Sciences (Ob’edinennyi Institut Vysokikh Temperatur RAN)
- Issue: Vol 54, No 5-6 (2018)
- Pages: 298-303
- Section: Article
- URL: https://journals.rcsi.science/0009-2355/article/view/236274
- DOI: https://doi.org/10.1007/s10556-018-0478-z
- ID: 236274
Cite item
Open Access
Access granted
Subscription Access
Abstract
The possibility of enhancing heat exchanger efficiency by applying capillary-porous coatings onto the surface of a heating element using gas-thermal spray techniques is explored. Aluminum oxide porous coating was applied by electric-arc metallization using AMC wire of 1.6 mm diameter as the coating material. Aluminum oxide coatings were applied by spraying filamentous material with a Top–Jet gun.
About the authors
V. M. Gusev
Russian State University of Oil and Gas (Rossiiskii Gosudarstvennyi Universitet Nefti i Gaza)
Author for correspondence.
Email: sfynx13@mail.ru
Russian Federation, Moscow
A. G. Buklakov
Russian State University of Oil and Gas (Rossiiskii Gosudarstvennyi Universitet Nefti i Gaza)
Email: sfynx13@mail.ru
Russian Federation, Moscow
P. A. Konovalov
Joint Institute for High Temperatures, Russian Academy of Sciences (Ob’edinennyi Institut Vysokikh Temperatur RAN)
Email: sfynx13@mail.ru
Russian Federation, Moscow
A. S. Tyuftyaev
Joint Institute for High Temperatures, Russian Academy of Sciences (Ob’edinennyi Institut Vysokikh Temperatur RAN)
Email: sfynx13@mail.ru
Russian Federation, Moscow
