Email this article Investigation and a Technique for Calculating the Mode of Deformation of the Bayonet Catch of the Steam Chamber of a Bpm-100 Automatic Line
- Authors: Kochetov V.I.1, Lazarev S.I.2, Baronin G.S.2
-
Affiliations:
- Research Institute of Rubber Machinery (NIIRTMash)
- Tambov State Technical University
- Issue: Vol 52, No 7-8 (2016)
- Pages: 441-451
- Section: Research, Design, Calculations, and Operating Experience
- URL: https://journals.rcsi.science/0009-2355/article/view/234845
- DOI: https://doi.org/10.1007/s10556-016-0212-7
- ID: 234845
Cite item
Open Access
Access granted
Subscription Access
Abstract
A computational procedure and technique for computing the strength and tension of a bayonet catch (represented as a thin short cylindrical shell, with a ring on one edge of the shell and teeth along the other edge) loaded on the side of the teeth with a regular load are proposed. It is shown that with this type of loading, the stresses and displacements differ significantly from the computed values obtained in axisymmetric loading.
Keywords
About the authors
V. I. Kochetov
Research Institute of Rubber Machinery (NIIRTMash)
Email: geometry@mail.nnn.tstu.ru
Russian Federation, Tambov
S. I. Lazarev
Tambov State Technical University
Author for correspondence.
Email: geometry@mail.nnn.tstu.ru
Russian Federation, Tambov
G. S. Baronin
Tambov State Technical University
Email: geometry@mail.nnn.tstu.ru
Russian Federation, Tambov
