Organizing Interaction of Basic Components in the CNC System AxiOMA Control for Integrating New Technologies and Solutions
- Authors: Martinov G.M.1, Nikishechkin P.A.1, Grigoriev A.S.1, Chervonnova N.Y.1
-
Affiliations:
- Moscow State Technical University (STANKIN)
- Issue: Vol 80, No 3 (2019)
- Pages: 584-591
- Section: Automation in Industry
- URL: https://journals.rcsi.science/0005-1179/article/view/151345
- DOI: https://doi.org/10.1134/S0005117919030159
- ID: 151345
Cite item
Abstract
The article substantiates the need to have higher openness of modern CNC system for integrating new technologies and solutions. The additional, multi-task communication channel between the terminal part and core of CNC system is offered for implementing the interaction between additional software-hardware modules. The practical aspects of usage of offered mechanisms is shown on example of two software-hardware solutions. Which were integrated into the structure of the CNC system AxiOMA Control.
About the authors
G. M. Martinov
Moscow State Technical University (STANKIN)
Author for correspondence.
Email: martinov@ncsystems.ru
Russian Federation, Moscow
P. A. Nikishechkin
Moscow State Technical University (STANKIN)
Author for correspondence.
Email: pnikishechkin@gmail.com
Russian Federation, Moscow
A. S. Grigoriev
Moscow State Technical University (STANKIN)
Author for correspondence.
Email: info@avtprom.ru
Russian Federation, Moscow
N. Yu. Chervonnova
Moscow State Technical University (STANKIN)
Author for correspondence.
Email: info@avtprom.ru
Russian Federation, Moscow
Supplementary files
