Open Access Open Access  Restricted Access Access granted  Restricted Access Subscription Access

Vol 52, No 1 (2016)

Direct Conversion of Solar Energy to Electric Energy

Direct solar conversion to electricity nanoscale effects in pSi–n(Si2)1–x(ZnSe)x (0 ≤ x ≤ 0.01) of solar cells

Saidov A.S., Amonov K.A., Kutlimurotov B.R.

Abstract

Epitaxial layers of the solid solutions (Si2)1–x(ZnSe)x (0 ≤ x ≤ 0.01) of n-type conductivity on pSi base were cultivated by liquid phase epitaxy from a restricted amount of tin solution–melt. The spectral photosensitivity dependence of the pSi–n(Si2)1–x(ZnSe)x structure was studied. A peak was discovered in the response level within the interval of photon energy from 2.67 to 3 eV conditioned by the energy band of ZnSe “quantum dots,” which is located ~1.55 eV lower than the ceiling of the silicon valence band.

Applied Solar Energy. 2016;52(1):1-4
pages 1-4 views

State and prospects of solar cells based on perovskites

Ashurov N.R., Oksengendler B.L., Rashidova S.S., Zakhidov A.A.

Abstract

The paper discusses the basic problems of the current state of research on solar cells based on organic–inorganic perovskites. The timeline of the research development in this field, the structural aspects of this perovskite class, the architecture of solar cells based on them, and the core technological aspects (in particular, aspects associated with multifaceted importance of polymers) of the creation of device structures are considered. In addition to these experimental aspects, the most important theoretical problems are addressed, such as lattice energy, defect states in pure and mixed perovskites, and degradation effects associated with moisture and photoirradiation. The given references cover the entire spectrum of research problems in the field of solar cell based perovskites, since the start of these studies and to date.

Applied Solar Energy. 2016;52(1):5-15
pages 5-15 views

Solar Power Plants and Their Application

Energetic and exergetic performance evaluation of natural circulation solar water heating systems

Kaushik S.C., Ranjan K.R.

Abstract

This study deals with the energy and exergy analyses of natural circulation solar water heating (SWH) systems. The system comprises of a single glazed flat plate solar collector (FPSC) with absorber plate of 2 m2, and a separate insulated well-mixed vertical water storage tank (WST) of 125 liters. The variable heat transfer coefficients, water inlet and outlet temperatures of the FPSC; and temperature of heated water stored in the WST are predicted theoretically for each interval. The daily energy and exergy efficiency of the FPSC, WST and SWH system are estimated to be about 39 and 4.36%, 67 and 38.55%, 27 and 1.01%, respectively. It is found that the water inlet temperature, optical efficiency and the solar radiation strongly influence the performance of the FPSC both energetically and exergetically. It is observed that change in the mass flow rate of water improves the exergy efficiency of the FPSC significantly. FPSC has been identified as a critical component of the system where exergy destruction of 308 W/m2 takes place daily as compared to 24 W/m2 in the WST against available solar exergy of about 663 W/m2.

Applied Solar Energy. 2016;52(1):16-26
pages 16-26 views

Modelling of a hybrid photovoltaic thermal collector based on CdTe

Haloui H., Touafek K., Zaabat M., Hocine H.B., Khelifa A.

Abstract

A few years ago, silicon photovoltaic panels had yields of 10 to 18%, which made them interesting because is not profitable enough (too expensive to energy conversion yield too low).But recently, thin film technology appears to increase the efficiency and reduce the cost. For application in hybrid collectors, various types of solar photovoltaic hybrid collectors (PVT) based on new materials for solar cells have been developed as the binary semiconductor, ternary and quaternary materials and organic. CdTe is a the most appropriate binary materials for use in photovoltaic structures in thin layers, this material can produce a high yield of about 15% and is also known by a direct band structure gap of a value of 1.45 eV and a very high absorption coefficient (>105 cm–1 in the visible). In this work we present the modeling of a hybrid photovoltaic thermal collector based on the thin films solar cells of CdTe, and then we made the determination of the temperature levels of the various layers through the development of the energy balance sheet involves heat exchange between the different components of the collector and to study its electrical and thermal performance, and finally compare their efficiency with it of the PVT collector based on monocrystalline silicon.

Applied Solar Energy. 2016;52(1):27-31
pages 27-31 views

Highly efficient dye-sensitized solar cell prepared by electrophoretic deposition method: the effect of TiO2 films thickness on the performance of cells

Nasirian A., Mirkhani V., Moghadam M., Tangestaninejad S., Mohammadpoor-Baltork I., Keshavarzi R.

Abstract

In this work, nanocrystalline P25 TiO2 films with different thicknesses were deposited on FTO coated glass substrates by an electrophoretic deposition technique (EPD) and applied as the work electrode for dye-sensitized solar cells (DSSC) using cis-bis(isothiocyanato)(2,2'-bipyridyl-4,4'-dicarboxylato)(4,4'di-nonyl-2'-bipyridyl) ruthenium(II) (Z907, Dyesol) as sensitizing dye.The results showed that the increasing the thickness of TiO2 films lead to increase the adsorption of the dye on the TiO2 layers which in turns improved the short-circuit photocurrent (Jsc) and open-circuit voltage (Voc), respectively. Furthermore, it was found that the effects of the surface states on the recombination of the photo-injected electrons (electron–hole pairs) in the TiO2 films strongly depend on theTiO2 electrode annealing temperature. Finally, a DSSC with a 32.82 μm thickness for TiO2 film annealed at 600°C produced the highest conversion efficiency with an incident solar energy of 100 mW/cm2 (η = 8.23%, Jsc = 15.98, Voc = 0.73, FF = 0.7).

Applied Solar Energy. 2016;52(1):32-39
pages 32-39 views

Simulation of convective heat removal in a stratified tank of the integrated collector storage solar water heater with builtin heat exchanger

Oshchepkov M.Y., Frid S.E.

Abstract

Free convective heat removal in a stratified inclined storage tank with builtin heat exchanger is numerically simulated. The effects of coolant flow rate and tank installation angle on heat transfer are investigated. The possibility of the integration of several of tanks into the battery is analyzed. If there are not many tanks, their serial connection in the battery is more preferable than parallel because of the significant output gain.

Applied Solar Energy. 2016;52(1):40-46
pages 40-46 views

Heat pipes application to solar energy systems

Khairnasov S.M., Naumova A.M.

Abstract

Today widespread application of energy-saving equipment based on heat pipes makes a significant contribution to the task of resources saving. Using the heat pipes as heat transfer and heat exchange design elements allows creating new effective equipment generation for solar energy systems. Heat pipes are widely used both to improve the outdated equipment, increase its efficiency, reliability and lifetime and in the creation of new high-quality and economic technology samples. Up to the present day there are the following systems and solar energy equipment where heat pipes are widely used: photovoltaic-thermal solar collectors, solar thermal collectors, concentrating photovoltaic and concentrating solar plant. The article presents an analysis of the current state and prospects of heat pipes using in solar energy systems.

Applied Solar Energy. 2016;52(1):47-60
pages 47-60 views

Heliotechnical Materials Science

The study of factors that influence on the effectiveness of the photoconversion of n-CdS/p-CdTe heterostructures

Kabulov R.R., Makhmudov M.A., Ataboev O.K., Khazhiev M.U.

Abstract

The load characteristics of n-CdS/p-CdTe heterostructures were studied at different lighting levels with monochromatic light (λ = 632.8 nm) and white light with different spectra of radiation. It was established that the efficiency of conversation of a structure increases with increased temperature upon lighting with white light from an incandescent lamp. The results will help to optimize the structure of photocells based on CdTe polycrystalline films.

Applied Solar Energy. 2016;52(1):61-67
pages 61-67 views

Solar Radiation

Enhancing of solar pumped liquid laser efficiency

Payziyev S., Bakhramov S., Shayimov F.

Abstract

The neodymium-containing phosphorus oxychloride liquid laser material is studied as an active medium for pumping by concentrated solar radiation at the focus of small-size parabolic-dish concentrators. The possibility of increase its efficiency by means of frequency-down-shifting elements of solar spectrum is examined by simulation calculations by Monte-Carlo and ray-tracing methods using. More than 40% efficiency increase is obtained.

Applied Solar Energy. 2016;52(1):68-71
pages 68-71 views